The printer on the foto is a label printer (xi series) The 330i (P330i) is a card printer (out of paper?!?) send the command !SA to calibrate the ribbond and the CADS.
If is like the foto. run sensor profile, check if see the gaps, if not, check fisicly the two sensors behind the printhead if they are on the same position, They need to mach. Run manual calibration. Hope help you.
Answers & Comments
The printer on the foto is a label printer (xi series)
The 330i (P330i) is a card printer (out of paper?!?) send the command !SA to calibrate the ribbond and the CADS.
If is like the foto. run sensor profile, check if see the gaps, if not, check fisicly the two sensors behind the printhead if they are on the same position, They need to mach.
Run manual calibration.
Hope help you.