I have an Intellicorder 0 model 180. It has no longer works. All was fine until I went into the menu to erase the captured video. I selected Erase All and OK when prompted. After that the screen went blank and it would not turn on. I suspect that this action has erased more than the captured video from memory. Pressing the reset button does nothing. Any ideas on getting this unit to work again?
Your recorder hangs up due to performing a heavy task. the system must be reset if the reset button did not solve the problem try to remove the battery after removing press and hold the pwer button for atleast 30 sec-to 1 minutes to drain the voltage supply present this will reset the system then return the battery and power on again.If this procedure did not work connect your recorder to a computer and browse the files you want to delete and erase it one by one.then restore default value. again if that did not work you need to bring your unit to the service center the application program of your recorder is corrupted and need to be re install....good luck!
Answers & Comments
Your recorder hangs up due to performing a heavy task. the system must be reset if the reset button did not solve the problem try to remove the battery after removing press and hold the pwer button for atleast 30 sec-to 1 minutes to drain the voltage supply present this will reset the system then return the battery and power on again.If this procedure did not work connect your recorder to a computer and browse the files you want to delete and erase it one by one.then restore default value.
again if that did not work you need to bring your unit to the service center the application program of your recorder is corrupted and need to be re install....good luck!