I HAVE FORMATTED MY PC AND RELOADED THE WINDOWS XP, AFTER LOADING THE HARDWARE DRIVER, SOMETHING WENT UNUSUAL AND SYSTEM SHUTSDOWN EACHDOWN WHEN AFTER BOOTING WINDOWS XP. THEN I RELOADED WINDOWS XP AGAIN. SYSTEM BECOME STABLE BUT HARDWARE DURING POST STOP DETECTING MY SATA DVD BURNER, WHERE AS SAME DVD BURNER I CHECKED IS WORKING IN ANOTHER PC. SHOULD I UPDATE THE BIOS OF MY MOTHER BOARD?, MAY BE IT WILL SOLVE MY PROBLEM..I AM SUSPECTING THAT SATA PORT OF MOTHERBOARD HAS BEEN DAMAGED. HARDDISKS ARE CONNECTED THROUGH IDE TERMINAL
Computers & Internet - EliteGroup - ECS P4M800-M Socket 478/P4M800/FSB800/A&V&L/M-ATX...
Test your PSU or replace it if your power supply units fan is not working your PSU is faulty
One bad lead can cause a computer to continue on a cycle or to shutdown or fail to detect/ boot up a computer hard drive
Test all leads that attach to your hard drive including electrical extensions,IDE,SATA
the leads from your ((motherboard to your hard drive)) make sure they have a secure connection and are not faulty or just replace them there probably old and faulty make sure all leads that are attached to your drives dvd\cd 3 1/2 inch floppy have secure connections and are not faulty even the electrical extensions or just replace them they are probably old and faulty a computer needs its connections to have an end so any faulty leads will end up with a computer error hope this helps
Answers & Comments
Test your PSU or replace it if your power supply units fan is not working your PSU is faulty
One bad lead can cause a computer to continue on a cycle or to shutdown or fail to detect/ boot up a computer hard drive
Test all leads that attach to your hard drive including electrical extensions,IDE,SATA
the leads from your ((motherboard to your hard drive)) make sure they have a secure connection and are not faulty or just replace them there probably old and faulty
make sure all leads that are attached to your drives dvd\cd 3 1/2 inch floppy have secure connections and are not faulty even the electrical extensions or just replace them they are probably old and faulty a computer needs its connections to have an end so any faulty leads will end up with a computer error
hope this helps