I HAVE INSTALLED MY NEW SUPER ALLWRITE DVD BURNER AND ACCORDING TO THE WIZARD, I HAVE INSTALLED IT RIGHT. NOW, MY SPEAKERS WILL NOT WORK NOW MATTER WHICH PORT YOU PLUG THEM IN. WHERE DID I GO WRONG?
Computers & Internet - Lite On - LH-20A1H DVD RW Dual Layer Burner
Answers & Comments
You may have dislodged a cable whilst installing it.
speakers should always go into the same port which is usually colour coded green for ease of use. plugging them in elsewhere could on occasion cause other problems.
Also double check in the volume control properties that none of the sound playback devices have been MUTED and that the levels are all set to about half.
Most drives today can playback audio without anything other than the power cable and the data cable being plugged in correctly.
Some however do come with a thin cable that would go from the drive to either the motherboard or sound card. is that is the case then you should check your manuals for your sound hardware and make the required connection.