I have no power to my kenmore dishwasher. breakers looks ok
No power to my kenmore dishwasher. It was working fine this afternoon. I went to unload it and found that there is still water in the bottom. When trying to reset the cycle I could not get the control panel to work. It seems like there is no power to the unit as an extension cord that comes from behind the DW (and I assume the same outlet) powers the garbage disposal does not work either. The circuit breaker looks ok - I have shut it off and on twice but with no change in results.
I am looking at pulling the unit out from under the counter but I do not have a small enough socket wrench to undo the leg levelers.
Help!
I am looking at pulling the unit out from under the counter but I do not have a small enough socket wrench to undo the leg levelers.
Help!
Dishwashers - Kenmore
Answers & Comments
If both units are not working there is a power supply issue. It sounds like from what you are saying that there is a power supply behind your dishwasher and you need to remove the machine to access the power source. If so here you go.
The dishwasher is likely screwed into the underside of the counter as well at held by the legs. Look for the screws and remove. You should have enough room to lift the machine a little and slide it out.
To turn the legs the foot itself turns. You turn the foot not the fitting where it attaches to the machine. Here it is usually done with slip joint pliers or a crescent wrench.
Hope this helps. Please rate this solution.