I just installed a new EVGA x58 classified motherboard to a new chassis (HAF 932 - full tower) and when I touch the power button all of the components light up for a second, the fans start to turn but then it stops. It's as if I am not getting enough power. The motherboard lights (memory stand-by blue LED light and main "E" red light) are on, so I know it is getting power. What could be the problem? I followed the instructions precisely
Computers & Internet - Evga - 121-BL-E756-TR Motherboard
Answers & Comments
Hi friend,
You need to change your RAM because your memory not able to transfer data. just change your RAM then it will work.
Your problem could be that your power supply is no longer functioning properly. Otherwise, did you make sure you were properly grounded when you did the installation? Maybe something got shorted out. You may try putting a new battery on the motherboard. And last but not least, check your CMOS jumper setting usually located near the battery, if it is set to reset change it.