I just put a clutch in my 96 Geo Prizm with pleasure plate and throwout bearing now I can't get it into reverse,first gear is hard to get and 5th gear will not engage could this be a linkage problem?
Its a hydra. clutch. acutator so did you check that first. and bleed it? no air allowed. there. did you prove the clutch MC and slave were good first before replacing the whole main clutch>? before the job started was the MC dry? clutch master cylinder, MC. the bleed in on the rear of the SLAVE>
Answers & Comments
Its a hydra. clutch. acutator
so did you check that first. and bleed it?
no air allowed. there.
did you prove the clutch MC and slave were good
first before replacing the whole main clutch>?
before the job started was the MC dry?
clutch master cylinder, MC.
the bleed in on the rear of the SLAVE>
Sounds like you did not bleed all the air out of the hydraulic clutch system.