Hi, Cheri Torres with DISH Network Customer Service here. Icame across your post wanted to see if I could help. The first thing you aregoing to want to check is that you have the correct tab in the front of the TV2remote. If there is a blue TV2 tab in the remote right now you are going towant to take the battery cover off the remote and pull out the blue tab, turnit over and there should be a green TV1 tab on the opposite side, reinsert thetab with the green TV1 tab facing up. I am going to list here for you theinstructions for readdressing the remote to the receiver. Make sure that youare in front of your DISH Network receiver box when you follow these steps. Ihope you find this information useful and if you have any further questions orconcerns feel free to post back here or email me [email protected] Instructions for addressing your remote to your DISH receiver.
Go to System Info screen. You can do this by either pressing the system info button on the front of the receiver box or by pressing the power button once and the channel up button once on the front of the receiver. You may need to open the little door on the front right side of the receiver to locate the buttons.
Once you are in the system info screen you will see primary remote address(TV1) and secondary remote address(TV2). For your particular situation you will look for primary remote address.
Hold down the SAT button until all mode lights light up.
Enter a number between 1 and 15 using the numeric keypad on the remote.Change the number to something different then what is already listed in the white square.
Press the pound (#) button
Once the SAT button blinks three times, press record. Note: If successful the number selected in step 4 will appear in the System Info screen under Remote Address.
Answers & Comments
Hi, Cheri Torres with DISH Network Customer Service here. Icame across your post wanted to see if I could help. The first thing you aregoing to want to check is that you have the correct tab in the front of the TV2remote. If there is a blue TV2 tab in the remote right now you are going towant to take the battery cover off the remote and pull out the blue tab, turnit over and there should be a green TV1 tab on the opposite side, reinsert thetab with the green TV1 tab facing up. I am going to list here for you theinstructions for readdressing the remote to the receiver. Make sure that youare in front of your DISH Network receiver box when you follow these steps. Ihope you find this information useful and if you have any further questions orconcerns feel free to post back here or email me [email protected]
- Go to System Info screen. You can do this by either pressing the system info button on the front of the receiver box or by pressing the power button once and the channel up button once on the front of the receiver. You may need to open the little door on the front right side of the receiver to locate the buttons.
- Once you are in the system info screen you will see primary remote address(TV1) and secondary remote address(TV2). For your particular situation you will look for primary remote address.
- Hold down the SAT button until all mode lights light up.
- Enter a number between 1 and 15 using the numeric keypad on the remote.Change the number to something different then what is already listed in the white square.
- Press the pound (#) button
- Once the SAT button blinks three times, press record. Note: If successful the number selected in step 4 will appear in the System Info screen under Remote Address.
Instructions for addressing your remote to your DISH receiver.