I made changes to my Intellinet MIMO Wireless Turbo G Router using the IP address to access its operating system online. I was attempting to force a password so that only those with a password could access the internet. After making the changes, it seemed to work for about 30 minutes, then all access was stopped. I cannot access the router wirelessly or otherwise. What can I do to either regain access through the IP address or reset the router to previous or default settings?
Computers & Internet - Intellinet Active Networking - Intellinet Wireless Router with 4 Port Switch (521246)
Answers & Comments
Usually the way to reset the router to the factory settings is to push in and hold the re-set button for more than 4 seconds. The reset button will be located at a small hole on the back and might require you to use a small pen or screwdriver to push it. Just push the button until all the lights re-set and this should bring it back to the factory settings. After you have done this then you will be able to use the factory password to get into the router. The default user name will be "admin" password is "1234"