I moved from wa.state and upon connecting the freezer the motor came on but it would not get cold. is there a reset button that needs to be reset . what doyou suggest that can be tried to have it freeze. it work great before moving
Freezers - Haier - 3.5 cu. ft. Chest Freezer HNCM035E
Answers & Comments
Hello,
There is a coil in the compressor which is making the compressor pump gas into the pipe thereby making the freezer cool. If this coil gets burnt, the compressor won't pump gas and the freezer won't get cold.
If the compressor is defective, and you don't have money to buy another one, you can open up the compressor, remove the coil and get it recoiled, then replace it back into the compressor.
There are two or more reasons that can cause this problem.
1. it is either the gas in the compressor has leaked when the freezer was being moved or 2. the pipe that run from the compressor to the freezer might be leaking.
So, turn on the freezer, look at the back, observe the pipe that runs from the compressor to the freezer.
Lastly, the thermostat can be a problem sometimes. The Thermostat might have been reduced to the lowest level unknowingly to you. Check the thermostat make sure it is increased to the highest as this will increase the temperature and make the freezer cool.
Good luck.