Those are all the codes from the manual for Sharp T.V.s
So now turn the item on you want to control with the remote.
Press the corresponding button.
Hold "set" till the LED stays steady.
Enter the 4 digit code.
When entering the 4th number the LED should shut off.
This means that your remote is set for that device.
Press OK to store the code.
If the LED blinks 3 times and goes steady again the the code is not the one you want and you need to start an step 1 again.
You can also try the Code Search Function
Turn on the device you wish to match with your remote.
Aim the remote at the device and press and hold the Code Search button in the upper left of your remote for at least 3 seconds until the LED light on the remote turns a solid red.
Press the button on the remote for the item you want to program.
The LED light should blink once and then remain a solid red.
Press the On/Off button slowly until the device you want to program turns off.
The LED light will blink once each time you depress the On/Off button.
When the device you want to program turns off, press the ENTER button.
The LED button will turn off and the code for that device will be stored in your remote.
Answers & Comments
Regards, Tony