SC27-4: Output of toner density sensor cannot be controlled.
If someone has removed the lid of the developer tank then you will get this fault. It is possible you will have to replace the developer tank in order to get this fault to resolve.
You should check the connnector to the toner sensor on the developer tank to make sure it is not disturbed.
Disconnect printer from mains altogether and then power up again. If problem does not resolve - replace developer tank.
Hope this helps. Please remember to rate my answer. Many Thanks.
Answers & Comments
Hi
This error is as follows
SC27-4:
Output of toner density sensor cannot be controlled.
If someone has removed the lid of the developer tank then you will get this fault. It is possible you will have to replace the developer tank in order to get this fault to resolve.
You should check the connnector to the toner sensor on the developer tank to make sure it is not disturbed.
Disconnect printer from mains altogether and then power up again. If problem does not resolve - replace developer tank.
Hope this helps. Please remember to rate my answer. Many Thanks.
Normal printer resents if you unplug the device without turning it off and leave it like that for at least an hour, better if over night.
what was the last thing you tried to do before the error occurred?
Hi...
Error Code : SC27-4:
Output of toner density sensor/K (TDS K) cannot be controlled.
Unplug the power cord that should reboot the copter.
Let me know
Thanks
Smith