I could not locate your exact model ending with a 1, but I do have a parts breakdown and assemby diagram. This should help you verify assembly after you assembled the safety clutch. Click this link: http://consew.marginspluslive.com/images/products/PARTSBO/226r2parts.pdf
Was the diagram sent correct for your unit??? What any power leads disconnected on this machine when replacing parts????Was the diagram sent correct for your unit??? What any power leads disconnected on this machine when replacing parts????
If your assembly and parts are back to original positions, you can contact Consew at the following locations. New York 212-741-7788 or Florida 305-471-0200If your assembly and parts are back to original positions, you can contact Consew at the following locations. New York 212-741-7788 or Florida 305-471-0200
Thanks for using FixYa. This could be due to the needle. Do not use the start/stop button when the foot controller is connected. To use the start/stop button, disconnect the foot controller.
Please do accept the solution if the issue is resolved or else revert for further assistance.
Answers & Comments
I could not locate your exact model ending with a 1, but I do have a parts breakdown and assemby diagram. This should help you verify assembly after you assembled the safety clutch.
Click this link: http://consew.marginspluslive.com/images/products/PARTSBO/226r2parts.pdf
Was the diagram sent correct for your unit??? What any power leads disconnected on this machine when replacing parts????
If your assembly and parts are back to original positions, you can contact Consew at the following locations. New York 212-741-7788 or Florida 305-471-0200
Hi
Thanks for using FixYa. This could be due to the needle. Do not use the start/stop button when the foot controller is connected. To use the start/stop button, disconnect the foot controller.
Please do accept the solution if the issue is resolved or else revert for further assistance.
Thanks
Rylee
Try replacing the needle and you'll know.
Thanks
Rylee