I try to light my heater, holding red button in and hitting the igniter button,the flame is burning but when i let go of the button, after 30 seconds the flame goes out, every time
Heating & Cooling - Reddy - HEATER RLP30 30,000-BTU PORTABLE LP PROPANE FORCED AIR...
Answers & Comments
It could be either a defective thermocoupler (which would look like the tip is corroded and shortened) or the thermal switch kit may have dirty electrical connection at one or all of the spade clips (pull each clip and clean with an abrasive like sand paper then replace the clips making sure they are tight. If the pilot still won't stay lit, the thermal switch may have gone bad. Jump it out to verify. I found parts online at http://www.cart32hosting.com/estore/template/thumbnails.php?id=010780&cid=39 Good luck!
I have a rlp30a and my friend lit it without plugging in the fan!!! now it will not work..any ideas?