Here are all the hacks known out there for the Maratnz DVD players. If thease do not work then there is not one for the player.


Turn on player without disk and wait for "No Disk" on front panel display.
On front panel, press and keep pressed Pause, while you enter 3,1,4,1,5,9 on remote.
Release Pause immediately after the "9".
The word CODE is displayed on panel.
Press number of region, or 0 for all regions.
Press Pause on panel again .

Turn the power off.
Keep holding [DIMMER] and [Previous] key together and switch power on.
Display will show: '---------',
With remote handset of the player, press [1],[9],[9],[9].
Enter the following 2-digit number: [0],[0].
Press [Enter] on the remote handset.

Turn on player without disk and wait for "No Disk" on front panel display.
On front panel, press and keep pressed Pause, while you enter 3,1,4,1,5,9 on remote.
Release Pause immediately after the "9".
The word CODE is displayed on panel.
Press number of region, or 0 for all regions.
Press Pause on panel again .

Turn on the player with no disc in the tray.
Press Next (on front panel) and Previous (on front panel) at the same time.
The display shows Region 2.
Press Stop (on front panel) for 5 seconds.
The display now shows Region 0.
Press Play (on front panel).
The display should show Region 0 OK.
Turn power off and on.

Turn on player without disk and wait for "No Disk" on front panel display.
On front panel, press and keep pressed Pause, while you enter 3,1,4,1,5,9 on remote.
Release Pause immediately after the "9".
The word CODE is displayed on panel.
Press number of region, or 0 for all regions.
Press Pause on panel again .

Turn on player without disk and wait for "No Disk" on front panel display.
On front panel, press and keep pressed Pause, while you enter 3,1,4,1,5,9 on remote.
Release Pause immediately after the "9".
The word CODE is displayed on panel.
Press number of region, or 0 for all regions.
Press Pause on panel again .