Im getting ready to replace the convergence board IC's on my tv model # AV-56WP30 , what does the power resistor look like . and how do i check it to make sure that it is not bad ? is there more than one that should be checked ?
Resistors look like this http://personal.ee.surrey.ac.uk/Personal/H.M/UGLabs/images/resistor_packages.jpg You can set your multimeter to ohm meter to measure the resistance so that you can compare it with the original value. The original value is determined by means of the color code on top of the resistor. The last band is tolerance or permissible error limit. The codes and their values can be found at the link below http://www.elexp.com/t_resist.htm
Answers & Comments
Resistors look like this
http://personal.ee.surrey.ac.uk/Personal/H.M/UGLabs/images/resistor_packages.jpg
You can set your multimeter to ohm meter to measure the resistance so that you can compare it with the original value. The original value is determined by means of the color code on top of the resistor. The last band is tolerance or permissible error limit. The codes and their values can be found at the link below
http://www.elexp.com/t_resist.htm
Let me know if you need more help,
Sai.