Clyinder and head:
In a cross patern
Tighten bolts to 8-10 ft-lbs (11-14 Nm).
Tighten bolts to 13-15 ft-lbs (18-20 Nm).
Loosen all bolts.
After screws are loosened from initial torque, tighten
head bolts in three stages. Tighten fasteners in
increasing numerical sequence (i.e. – 1, 2, 3 and 4). Tighten each screw to 8-10 ft-lbs (11-14 Nm).
Tighten each screw to 13-15 ft-lbs (18-20 Nm).
Mark cylinder head and head screw shoulder with a line.
Turn all bolts an additional 85 -95 .

Rocker Cover

Slowly snug all fasteners
in small increments (one turn at a time). Use a cross
pattern on the four large bolts) that fasten the lower
rocker box to head. This will bleed the tappets.
Tighten bolts to 18-22 ft-lbs (24-30 Nm).
Tighten bolts to 11-13 ft-lbs (15-18 Nm).
Tighten bolts to 135-155 in-lb (15-18 Nm).
Install upper rocker covers.
Place a new inner gasket on lower rocker box
assembly.
Place a new lower gasket on lower rocker cover.
Install upper rocker cover using screws with washers
and new fiber seals. Tighten screws to 10-14 ftlbs