Unplug the blender and remove the jar. Undo the screws securing the baseplate. Separate the baseplate and attached motor collar from the base housing.
To remove the switch housing, remove the decorative facing to get at the top screws. Remove the lower screws from inside the blender base.
Hold the fan to keep the motor shaft from turning as you unscrew the drive stud. Remove the shield and any washers. Unscrew the fan nut to remove the fan.
Disengage the strain-relief fitting from the housing. Remove the wire connector joining the power cord and the lead to the brush housing.
Label and disconnect the lead wires from the switch block. Remove the motor mounting bolts and lift out the motor if necessary.
To free brushes, remove the leads attached to the brush housing. Use a screwdriver to press lead terminal through the slot in housing. The brush spring may pop out (don't lose it!).
Answers & Comments
Follow this steps and fix it. God bless you
- Unplug the blender and remove the jar. Undo the screws securing the baseplate. Separate the baseplate and attached motor collar from the base housing.
- To remove the switch housing, remove the decorative facing to get at the top screws. Remove the lower screws from inside the blender base.
- Hold the fan to keep the motor shaft from turning as you unscrew the drive stud. Remove the shield and any washers. Unscrew the fan nut to remove the fan.
- Disengage the strain-relief fitting from the housing. Remove the wire connector joining the power cord and the lead to the brush housing.
- Label and disconnect the lead wires from the switch block. Remove the motor mounting bolts and lift out the motor if necessary.
- To free brushes, remove the leads attached to the brush housing. Use a screwdriver to press lead terminal through the slot in housing. The brush spring may pop out (don't lose it!).