Is there any tricks to installing throttle position sensor in 92 geo storm? Not adjusting. Simply take out two screws and replace part and reinstall screws is it that easy?
Yes its that easy, just make sure you engage the notch on it to the throttle body shaft. You may have to roll it past the screw holes to engage the notch. Then holding it in place on the throttle body, just roll it back to where the holes line up for the screws. Do not over tighten the screws
Answers & Comments
Yes its that easy, just make sure you engage the notch on it to the throttle body shaft. You may have to roll it past the screw holes to engage the notch. Then holding it in place on the throttle body, just roll it back to where the holes line up for the screws. Do not over tighten the screws