Is there anyway to get an amplified signal to my zone two speakers without an additional amplifier? Should I be using the Speaker "B" outputs?
I have a 6 speaker surround sound setup on Speaker A and two outdoor speakers on Speaker B. I've configured Zone Two to use the Speaker B output but can't get it to work. I only get a wispier from the outdoor speakers only when Zone one and Zone two have the same input. When they're on different inputs, I hear nothing outside.
Audio Players & Recorders - NAD - T754 Receiver
Answers & Comments
Check your speaker setup menu to make sure that zone 2 is enabled. Also, a lot of receivers only allow analog inputs to be used for zone 2, so if you are using something like hdmi, or optical than this might be the problem.