Jandy aqualink RS PDA does not show salt level or boost option even tho it is producing chlorine. I can go to the control box and set the level or put it in boost but it is a pain in the neck. It appears my water temp sensor is bad and does that have any effect
Turned out after a factory reset mine was set to 0%. It was annoying having to go through every setting but in the end I learned a lot about the system.
Answers & Comments
Turned out after a factory reset mine was set to 0%.
It was annoying having to go through every setting but in the end I learned a lot about the system.
Filter pump must be on and go to devices on you should be able to turn on aquapure make sure 4 pin is connected to aqualink