Your other drive will have to be jumped as Master. Should your computer still not recognize either drive. The Master drive needs to be on the very end of your cable and the Slave goes on the middle connector.You then, place the jumpers for both drives on the CS setting show in the drawing as the Default Setting.
Worldvet
Your other drive will have to be jumped as Master. Should your computer still not recognize either drive. The Master drive needs to be on the very end of your cable and the Slave goes on the middle connector.You then, place the jumpers for both drives on the CS setting show in the drawing as the Default Setting.
Answers & Comments
Jump the middle pins, second set from the right when looking straight on with the power connector on the right.
Worldvet
Your other drive will have to be jumped as Master. Should your computer still not recognize either drive. The Master drive needs to be on the very end of your cable and the Slave goes on the middle connector.You then, place the jumpers for both drives on the CS setting show in the drawing as the Default Setting.
Worldvet
If you do not understand this illustration, please describe what you do not understand.
Thanks,
Worldvet
Reading pins left to right: second set of pins, jump vertically
the next set to the right would be cable select, master/slave.