Just replaced fuel lines and primer bulb in my MAC 3516. I put the line coming from the fuel filter on the shortest port on the primer bulb and the line going to the carb on the longest port. Was this correct? The engine will start but will not keep running. Can this be caused by incorrect fuel mixture? Have tried the choke in all positionsl Arm's tired! Please help!
Garden - McCulloch - 16 Inch Gas Chain Saw MCC1635AK
Answers & Comments
Line from fuel filter goes directly into the inlet of the carburetor and the line from the snap in bulb that is marked "in" attaches to the other outlet connector on the carb. Last is the long side of the bulb goes to the return on the gas tank. The snap in bulb sucks the gas but not directly from the filter hose, it does this through the carb as if it were trying to not only **** in the fuel but also removing the air trapped in the carb. You'll notice that the bulb has a **** side and a discharge side, and the **** side goes directly to the carb outlet connector. I tried to make this a clear as possible, and I hope it helps.
I guess they will not allow the word SUC*. The * is a K. Sorry for using a proper word. S. or U. or C. or K.
Maybe I should of used draws no suc*s