JVA 2440 rotates continuously in spa mode
I have a RS4 and when I push the spa mode button, the Jandy JVA 2440 (greaseless) actuator spins continuously. The other valves (pool and solar) rotate 180 degrees correctly bu the spa valve continues to rotate. I thout it was just a valve problem but when I flick the toggle switch on the valve to the on 2 position, the valve rotates 180 degrees as it should. Any ideas?
Pool & Spa - Jandy - Aqualink Rs4 One Touch Control System Control System
Answers & Comments
If you remove the handel and open thr top of the actuator you will see a set nut on the center of the shaft that you use to set where the valve stops. If this is tight then you may have a bad micro switch in the unit and you should replace the actuator. Good luck.