Try leaving the ingnition switched on for 30 mins to reset the cut out (it thinks you have tried the wrong code 3 times) check the buttons and see if one is stuck or not clicking, If you get it started and the switchpad seems unreliable unplug the keyboard when the engine is running(this disables the cutout)
I seems to think you have entered the wrong code 3 times, leave the ignition on for 1/2 an hour and the green should go out, if so check for a stuck button (they wear) if one is sticky lift it with your nail or a pin and enter the code, if it works you will need to change the code to loose the sticky key (this varies, check in handbook)I seems to think you have entered the wrong code 3 times, leave the ignition on for 1/2 an hour and the green should go out, if so check for a stuck button (they wear) if one is sticky lift it with your nail or a pin and enter the code, if it works you will need to change the code to loose the sticky key (this varies, check in handbook)
It thinks it has been tampered with and is locked out, leave the ignition on for half an hour or so and it should go back to normal, before you do this check the keypad, see if any are soft as you allways use the same 4 and they can stick making any code wrong.If you get it working if you unplug the keypad from the harness when the engine is running it will allways restart.It thinks it has been tampered with and is locked out, leave the ignition on for half an hour or so and it should go back to normal, before you do this check the keypad, see if any are soft as you allways use the same 4 and they can stick making any code wrong.If you get it working if you unplug the keypad from the harness when the engine is running it will allways restart.
Answers & Comments
Try leaving the ingnition switched on for 30 mins to reset the cut out (it thinks you have tried the wrong code 3 times) check the buttons and see if one is stuck or not clicking, If you get it started and the switchpad seems unreliable unplug the keyboard when the engine is running(this disables the cutout)
I seems to think you have entered the wrong code 3 times, leave the ignition on for 1/2 an hour and the green should go out, if so check for a stuck button (they wear) if one is sticky lift it with your nail or a pin and enter the code, if it works you will need to change the code to loose the sticky key (this varies, check in handbook)
It thinks it has been tampered with and is locked out, leave the ignition on for half an hour or so and it should go back to normal, before you do this check the keypad, see if any are soft as you allways use the same 4 and they can stick making any code wrong.If you get it working if you unplug the keypad from the harness when the engine is running it will allways restart.