The problem is mainly caused by the transfer/separation corona arcing out. You will need to replace this unit, also the right door where the T/S corona makes contact will need insulating, in extreme cases you will need a replacement high voltage PCB, sometimes if the copier is in a damp environment this can cause the problem. It is not the sort of job you should try.have it serviced by a professional technician.Thanks
Answers & Comments
The problem is mainly caused by the transfer/separation corona arcing out. You
will need to replace this unit, also the right door where the T/S corona makes
contact will need insulating, in extreme cases you will need a replacement high
voltage PCB, sometimes if the copier is in a damp environment this can cause the
problem.
It is not the sort of job you should try.have it serviced by a professional technician.Thanks