Hi Dwayne: This error occurswhen performing thewhite leveldetection.Check: a - Thewhiteboardonwhether or not thisposition b -Glass andOptical c -UBSCard- (cardmay befaulty) d -BICUCard(may be faulty) e - Checktheoptics andconnectorstothe cards.
I have heard thatseveral timesafter cleaningthe mirrors of thescannerworked.
Hope this helps; also keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.
We cleaned the optics & it was fine for a month then code came back. We replaced the sbu board, still had code. Replaced the BICU board & still had code. Also the service mode changed to Japanese . Reflashed the firmware. Still has SC142. Found a troubleshooting guide that says 142 is defective CCD. We are going to replace the CCD and Lamp regulator board next and see what happens.We cleaned the optics & it was fine for a month then code came back. We replaced the sbu board, still had code. Replaced the BICU board & still had code. Also the service mode changed to Japanese . Reflashed the firmware. Still has SC142. Found a troubleshooting guide that says 142 is defective CCD. We are going to replace the CCD and Lamp regulator board next and see what happens.
Answers & Comments
Hi Dwayne:
This error occurs when performing the white level detection. Check:
a - The white board on whether or not this position
b - Glass and Optical
c - UBS Card - (card may be faulty)
d - BICU Card (may be faulty)
e - Check the optics and connectors to the cards.
I have heard that several times after cleaning the mirrors of the scanner worked.
Hope this helps; also keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.
Thank you for using Fixya, and have a nice day.
We cleaned the optics & it was fine for a month then code came back. We replaced the sbu board, still had code. Replaced the BICU board & still had code. Also the service mode changed to Japanese . Reflashed the firmware. Still has SC142. Found a troubleshooting guide that says 142 is defective CCD. We are going to replace the CCD and Lamp regulator board next and see what happens.
Well, keep us updated.