Hi Thanks for using FixYa. You’ll need to check the leaks from taps, inlet hoses, inlet washers, water valves and mixing chamber. There should be no signs of water within the top deck area. Check for obvious signs of leaks in the stand pipes, drain hose, pump, and air bell. The pump can leak if the pump bracket is not secured properly. Check size setting of Smart drive is correct. Check that the high water level which should be 10-110mm from the top of the agitator to the water. If it is less than 10mm, then splashing may be a problem. Empty bowl, remove then refit pressure pipe to Motor Controller and test. If water level is outside these limits, replace Motor Controller. If all these fail the best way to check leaks is to fill the bowl with water and detergent and identify the leak point. If there is no service hatch, the feet may be fully extended. Otherwise it could be that Smart drive was overloaded or in a humid environment. Too much detergent could have been used. A new neck ring for the outer bowl will reduce ‘phantom’ suds leaks. Changing the impellor on the pump should also reduce the the leaks. Please do accept the solution if the issue is resolved or else revert for further assistance. Thanks Rylee
Answers & Comments
Hi
Thanks for using FixYa. You’ll need to check the leaks from taps, inlet hoses, inlet washers, water valves and mixing chamber. There should be no signs of water within the top deck area. Check for obvious signs of leaks in the stand pipes, drain hose, pump, and air bell. The pump can leak if the pump bracket is not secured properly. Check size setting of Smart drive is correct. Check that the high water level which should be 10-110mm from the top of the agitator to the water. If it is less than 10mm, then splashing may be a problem. Empty bowl, remove then refit pressure pipe to Motor Controller and test. If water level is outside these limits, replace Motor Controller. If all these fail the best way to check leaks is to fill the bowl with water and detergent and identify the leak point. If there is no service hatch, the feet may be fully extended. Otherwise it could be that Smart drive was overloaded or in a humid environment. Too much detergent could have been used. A new neck ring for the outer bowl will reduce ‘phantom’ suds leaks. Changing the impellor on the pump should also reduce the the leaks.
Please do accept the solution if the issue is resolved or else revert for further assistance.
Thanks
Rylee