Lightning strike Lost picture and sound. All leds on power board are lit. led is lit on big board where the secondary power feeds in. The led next to the high voltage coil doesn't light. Was wondering if the strike hit the antenna input and fed through the back door, or went through the power supply. one voltage reading is -38 volts were the block diagram says should be +39. Should I purchase a schematic fo $20 or is there a site with free downloads? Don't know where to find a test point on the secondary power supply. Old TVs used to say the voltages on the boards where test points were
Televison & Video - Hitachi - 53FDX01B 53" Rear Projection Television
Good Day; Make sure when measuring voltages that your'e on the proper ground, all TV's this day has two grounds. The HIT has #'s near the components, LED's that light or do not light. YES, get info to trouble shoot further. Good Luck, big IRISH.
Answers & Comments
Good Day;
Make sure when measuring voltages that your'e on the proper ground, all TV's this day has two grounds. The HIT has #'s near the components, LED's that light or do not light. YES, get info to trouble shoot further.
Good Luck, big IRISH.