Lock won't operate
We are wondering if there is supposed to have 2 tabs on the battery pack or just one? It looks like one of our may be broken off. Would this affect the operating of the system.
Locks & Locksmithing - Kwikset - 909 909-15 Satin Nickel Smart Code SmartCode Signature...
Answers & Comments
Yes, it appears that the battery connector has been damaged. You will need to replace this in order to get your lock working properly again.
You can get a new connector at any RadioShack store, or any other electronics type store, or hobbyist shop. the replacement can be done with either a soldering iron or with simple crimp connectors to attache the new connector to the same colored wires on the damaged connector.
If you are going to solder the wires together, make sure you either use some heat shrink tubing (put on each wire before soldering them) or wrap some electrical tape around each wire after splicing, or use insulated crimp connectors to prevent shorting of the leads when done.
Hope you find this Very Helpful - Best regards!