I have this same truck, in order to remove the pan you must remove the engine mounts and Jack the engine off the mounts as high as possible, but are u sure the pressure is low? u have tested it with a mechanical gage? the oil pressure sending units in tease are very inaccurate, my has always read near zero since it was almost new, I put a mechanical test gage on it and found out it had 20 pounds at idle at 40 going down the road, yet gage reads really low.
Answers & Comments
Remove all bolts out pan drop pan but u may have to remove motor mount bolts and raise motor few inches to allow clearance to get pan out
I have this same truck, in order to remove the pan you must remove the engine mounts and Jack the engine off the mounts as high as possible, but are u sure the pressure is low? u have tested it with a mechanical gage? the oil pressure sending units in tease are very inaccurate, my has always read near zero since it was almost new, I put a mechanical test gage on it and found out it had 20 pounds at idle at 40 going down the road, yet gage reads really low.