To remove it, take the ignition out and there should be two wires that come out of it and you cut the black and white striped one and take the green ground wire off the coil for the spark plug and it should start up. i had to do this because i bought a bike without the key it took me hours to figure it out but it works
I would suggest that you go on line, under the Manufacturer of your pit bike, and find a local service shop-- You are likely going to have to take it to them, and have them use a master key, or drill out the lock!
Next time, be sure to keep a spare hanging on a designated nail in the sop-- where all the emergency keys are stored. I wish yo well-
Answers & Comments
Unclip ignition barrel will kick over
Or drill out barrel
To remove it, take the ignition out and there should be two wires that come out of it and you cut the black and white striped one and take the green ground wire off the coil for the spark plug and it should start up. i had to do this because i bought a bike without the key it took me hours to figure it out but it works
I would suggest that you go on line, under the Manufacturer of your pit bike, and find a local service shop--
You are likely going to have to take it to them, and have them use a master key, or drill out the lock!
Next time, be sure to keep a spare hanging on a designated nail in the sop-- where all the emergency keys are stored.
I wish yo well-
Mack B