Lost temp control on foot pedal & thumb control
Hello, my name is tim and our 250 just lost temp control at foot pedal & thumb control. panel control is working fine so im sure its in the remote.
need help for part.
Welding Tools - Miller - SYNCROWAVE 250 DX TIG RUNNER WELDER 951117
Answers & Comments
Re expressmetal problem
try welding with a diferent torch or some stick welding leads could be a problem with the tig torch power cable ( is it at water cooled torch) that has gone open circuit
If you have both a foot pedal and a thumb control and neither is working, the problem could be in the 14 pin remote connector on the welder. The pins inside the connector can get worn out and/or broken with regular changing of the remote.
You could also have a bad PC2 board, the front panel control comes after the interface to the remote control.
Regards,
Carl