Programming is done on 7310, 7324 and 7316 type sets.
Enter programming by pressing the feature key followed by **266344.When prompted to enter the password enter 266344.
The screen should say TERMINALS&SETS. The 4 top line/feature keys are now used for programming.
At the terminals&sets prompt, press the show key (top right arrow).
The display should now ask for an extension number. Enter extension number you want to change the line appearance on.
Press the show key (top right arrow)
The display should say Line Access.
Press the show key (top right arrow)
The display should say Line Assignment
Press the show key (top right arrow)
The display should ask for a line number
Depending on the version of system the line numbers can be lines 001-004, 025-028, 049-052 or 001-004, 031-034, 061-064.
The easier thing for you to do is to press the list soft key then the next key (bottom right arrow).
this will tell the line order and if the line is assigned to appear & ring or not.
Press the change key to change the status of the line on your set from unassigned to appear& ring on lines 001,002,003,004,and either 005,025 or 031 for line 5.
press the Rls key when finished