Machine shows a service code of sc 928
My dsm 615 stopped working an shows a code of sc-928
ricoh b121-17
ricoh b121-17
Office Equipment & Supplies - Gestetner - DSm615 Digital Imaging System
Copyright © 2024 QA.XPDF.PUB - All rights reserved.
Answers & Comments
The SC - 928 is a Memory error problem.
The machine detects a discrepancy in
the write/read data during its write/read
test (done at power off/on and at
recovery from low power or night/off
mode). To try to reset this code -- Turn the MAIN power switch off, wait about 30 secs. then turn switch back On.
Possible causes:
• Memory defective
• BICU defective
• Poor connection between BICU and
memory
The cheapest repair would be to replace the memory. It is rare the the connections came apart unless some one was in the back of the machine for some reason.
WHICH CHIP SET NEED TO REPLACE?
what is the other troubleshooting of that error?