Remove the metal cover by removing the screws along the bottom left edge and one in the rear top right corner, and loosening the ones at the hinge in the top center. Then remove the screw on the media sensor, and pull the ribbon cable out of it's socket. The sensor slides out from the circuit board side of the center plane.
Answers & Comments
Remove the metal cover by removing the screws along the bottom left edge and one in the rear top right corner, and loosening the ones at the hinge in the top center. Then remove the screw on the media sensor, and pull the ribbon cable out of it's socket. The sensor slides out from the circuit board side of the center plane.