I had the same problem. I solved it by going into program mode, then while holding down the function key, input one of the missing channel numbers. The channel should appear but is flashing. Now input a frequency for the channel and exit program mode. Repeat the sequence for the other missing channels. This procedure worked for me. Good luck.
Correction to my last post. Go into program mode. Without holding down the function key Input the missing channel number on the keypad and press enter. Hold in the function key and press 5 on the keypad. Input a frequency (6 numbers) and press enter. release the function key. You can now program the other parameters as required and come out of program mode.
Correction to my last post. Go into program mode. Without holding down the function key Input the missing channel number on the keypad and press enter. Hold in the function key and press 5 on the keypad. Input a frequency (6 numbers) and press enter. release the function key. You can now program the other parameters as required and come out of program mode.
i have a h16 and i can go to every channel in the program mode by typing this number in, but when i go to 1 it goes to the channel i was just on could you help me with this?i have a h16 and i can go to every channel in the program mode by typing this number in, but when i go to 1 it goes to the channel i was just on could you help me with this?
Answers & Comments
I had the same problem. I solved it by going into program mode, then while holding down the function key, input one of the missing channel numbers. The channel should appear but is flashing. Now input a frequency for the channel and exit program mode. Repeat the sequence for the other missing channels. This procedure worked for me. Good luck.
Correction to my last post. Go into program mode. Without holding down the function key Input the missing channel number on the keypad and press enter. Hold in the function key and press 5 on the keypad. Input a frequency (6 numbers) and press enter. release the function key. You can now program the other parameters as required and come out of program mode.
i have a h16 and i can go to every channel in the program mode by typing this number in, but when i go to 1 it goes to the channel i was just on could you help me with this?
I wish I had known. I solved it by making a cloning cable and cloning off another radio.