Model 3205 FA not picking up bobbin thread, needle goes down but doesn't pick up bobbin thread, needle not bent, macine was working fine then all of a sudden bobbin thread stopped. Can't even pick it up to start
- check ifu are using same needle model. - check hight of needle bar is ok - check timming between needle bar and hook. - check if your material is very stritch or no - check blad point of hook is ok or no best regards
Answers & Comments
- check ifu are using same needle model.
- check hight of needle bar is ok
- check timming between needle bar and hook.
- check if your material is very stritch or no
- check blad point of hook is ok or no
best regards