Mtx ampnot working
After installing my amp i tested it and then pulled the fuse to bridge the channels when i retested it wouldnt work so i re-done the wiring to the normal channels and then put the fuse back in but it still will not work not even the led is coming on now .
Both the fuses one under the bonnet and the one on the amp are still ok but it still will not power up .
many thanks for your help
nobby
Both the fuses one under the bonnet and the one on the amp are still ok but it still will not power up .
many thanks for your help
nobby
Car Audio & Video - Jl Audio - E1200 Car Audio Amplifier
Answers & Comments
Try disconnecting the power supply and ground completely and reconnecting it starting with the ground then power and then the remote lead- Ihad a kenwood that was picky like that and if you hooked it up in the wrong sequence it wouldnt go -but once i figured that out- i never had a problem with it again-till someone stole it-.haha good luck-why did you pull the fuse to bridge your amp?thats odd-any particular reason?