If the steps below are not successful I would call TW customer care line.
Turn on the device, such as your TV, that you want the remote to operate.
On your remote, press the corresponding device button [such as TV, DVD, CBL] and the OK/SEL buttons simultaneously for three seconds. The device LED will light indicating that it is ready to be programmed. Note: The LED will remain lit for 30 seconds, and the next step must be completed while it is on.
Point the remote control at the device and press the CH+ or CH- button. The remote will emit power on/off code signals. Continue to step up or down until your device turns off.
Verify that the correct code has been selected by pressing the POWER button. Your device should turn back on. If it does, try changing the channel to verify programming was successful.
Press the corresponding device button to store the code. The device LED will blink twice to confirm the code has been stored. Good luck
Answers & Comments
If the steps below are not successful I would call TW customer care line.
Turn on the device, such as your TV, that you want the remote to operate.
On your remote, press the corresponding device button [such as TV, DVD, CBL] and the OK/SEL buttons simultaneously for three seconds. The device LED will light indicating that it is ready to be programmed.
Note: The LED will remain lit for 30 seconds, and the next step must be completed while it is on.
Point the remote control at the device and press the CH+ or CH- button. The remote will emit power on/off code signals. Continue to step up or down until your device turns off.
Verify that the correct code has been selected by pressing the POWER button. Your device should turn back on. If it does, try changing the channel to verify programming was successful.
Press the corresponding device button to store the code. The device LED will blink twice to confirm the code has been stored.
Good luck