First loosen the canopy cover and make sure that all the mounting screws are securely tightened, and that the fan is connected securely to the mounteing plate. After tighteneng all that if the fan is still unsteady, completely clean all the blade surfaces. Then using clothes pins , start adding the clothes pips , like 2 or 3 at a time to a blade about 3/4 out from the center. Try adding to each blade until you compensate for some of the wobbling. By trial and error, increase the weight, shift the position of the clothes pins, and change the weight to different blades to get the best performance. Then when you are satisfied with the correction, tape coins to the top of the blade to replace the clothes pins. again with trial and error, ballance the weight to get the best condition.
Answers & Comments
First loosen the canopy cover and make sure that all the mounting screws are securely tightened, and that the fan is connected securely to the mounteing plate.
After tighteneng all that if the fan is still unsteady, completely clean all the blade surfaces. Then using clothes pins , start adding the clothes pips , like 2 or 3 at a time to a blade about 3/4 out from the center. Try adding to each blade until you compensate for some of the wobbling. By trial and error, increase the weight, shift the position of the clothes pins, and change the weight to different blades to get the best performance. Then when you are satisfied with the correction, tape coins to the top of the blade to replace the clothes pins. again with trial and error, ballance the weight to get the best condition.