My connex 3300 will not lock on correct frequency it either goes to 25 mhz or 28 mhz
I can change band switch and high low switch(on low it only goes to 25 mhz) on high 28 to 29 mhz nothing in between and receive is off also
Radio Communications - Connex
Answers & Comments
Turn the BAND knob (under the RF power selector switch) in conjunction with the High Low selector switch to choose band A, B, C and in the other position D, E, F. A listing of frequencies that can be tuned in this manner can be found by clicking the link below:
http://hotspotcb.com/charts/freqchar33.html
A few words of caution.. the FCC takes a very dim view of unauthorized use of frequencies. The only range of frequencies that you can legally use without an FCC issued license (in the U.S. anyway) are those in Range D. If caught transmitting on any of the other frequencies without the proper license(s) fines and imprisonment may result. No one ever expects to get caught - but plenty do. If you'd like to gain the use the 28Mhz and up frequencies, check out:
http://www.arrl.org/licensing-education-training
Amateur radio is not shackled by channels, power limits less than 1500 watts nor limited to AM and SSB modes. Check it out! Good luck!