My cub cadet LTX 1045 will not start. I parked it the last time I used it and it ran fine. Engine turns over, gas in the carb; but no spark. Safety switches all look ok. Oil level is fine
Troubleshoot by checking continuity from the M (magneto) pole of the ignition switch to ground. It should be open (no continuity from M pole to ground.
Methodically disconnect switches until M pole to ground shows open. Then test suspected switch.
A DMM or an inexpensive auto circuit lamp tester will do.
Answers & Comments
Brake switch
PTO switch
Seat switch
RCM / reverse switch
Could be any of the above.
Troubleshoot by checking continuity from the M (magneto) pole of the ignition switch to ground. It should be open (no continuity from M pole to ground.
Methodically disconnect switches until M pole to ground shows open. Then test suspected switch.
A DMM or an inexpensive auto circuit lamp tester will do.
Wiring diagram;
https://www.cubcadet-parts-direct.com/cub-cadet-parts-diagrams/cub-cadet-ltx1045-tractor-2013-13ax91at010-2013-13ax91at056-2013-13wx91at010-2013-13wx91at056-2013-electrical-schematic/AD-4285-4664-168112