My Hirundo is not drying well. After hours of spinning the clothers are still wet, and not like usual. The water is draining. Is there a heat elementy to replace? A vent to clear?
Washing Machines - Equator - EZ 3612 CEE Front Load Washer/Dryer
Copyright © 2024 QA.XPDF.PUB - All rights reserved.
Answers & Comments
Make sure all vents are clean and clear. Next, check the thermal fuse. It should be located just inside the rear of the dryer and is usually attached to the exhaust duct. It can be tested by using a multimeter or ohmmeter to test for continuity. A lack of continuity indicates a blown thermal fuse.
Another cause could be a faulty heating element. It can be tested in the same manner as the thermal fuse. Hope this helped and best wishes.
This is using a multimeter to test continuity for reference. Hope this helpled and best wishes.
These are "VENTLESS" units. There is no vent to clean or clear.
My Hirundo washer/dryer combo drum does not turn for spinning on wash and dry cycles