Hello, This is going to be a problem with your igniter/glow bar. Over time these get old and although you may see it glowing iit still may be bad. Your igniter should glow a brillient yellow and should ignite the gas within 15 seconds of the valve opening. If you have any other questions or concerns please feel free to comment again...Good Luck! Mike
Hello again, I would normally charge around $120 - $150 depending on make/model but thats in NY the part should cost no more then $40 if you are doing it yourself. Here is a link that will give you a list of Appliance repair company's in Houston.
Answers & Comments
Hello, This is going to be a problem with your igniter/glow bar. Over time these get old and although you may see it glowing iit still may be bad. Your igniter should glow a brillient yellow and should ignite the gas within 15 seconds of the valve opening. If you have any other questions or concerns please feel free to comment again...Good Luck! Mike
Hello again, I would normally charge around $120 - $150 depending on make/model but thats in NY the part should cost no more then $40 if you are doing it yourself. Here is a link that will give you a list of Appliance repair company's in Houston.
I have a question about your DCS RGS 305 range. Could you please contact me at [email protected]? Thanks.