My Pc wont boot no signal in my monitor Help!
My PC:
Abit IP35P
2x Team Elite 1gb
Sapphire Toxic HD 4850
Ok, back to my prob:
I installed another hard drive (ATA), my system hard drive is SATA, but after i added the new drive, my monitor wont boot or display anything, no signal. so i removed the hard drive. everythings the same, fans running, no beep, the power light is on except that after like 5 secs it will shutoff and power itself on again. T_T help. i tried the clear CMOS thingy at the rear panel. huhu./. help me. i really need my pc. ( sorry for my bad english) thanks.
Abit IP35P
2x Team Elite 1gb
Sapphire Toxic HD 4850
Ok, back to my prob:
I installed another hard drive (ATA), my system hard drive is SATA, but after i added the new drive, my monitor wont boot or display anything, no signal. so i removed the hard drive. everythings the same, fans running, no beep, the power light is on except that after like 5 secs it will shutoff and power itself on again. T_T help. i tried the clear CMOS thingy at the rear panel. huhu./. help me. i really need my pc. ( sorry for my bad english) thanks.
Computers & Internet - Abit - IP35P Motherboard
Answers & Comments
Hi there..in mobo with platform p35 works the same like that on-off and on again,its normal so dont worry about that
the real problem is screen blank,i've got replaced new mobo with the same type,but the problem still the same.so its not the mobo problem i think.
May be your in second HDD, you didn't set the jumper up. There are some more settings you will have to configure in the BIOS menu. in the BIOS, you should set the primary HDD as the master and the second(newer HDD) as the secondary. Then it should boot without any problem but if the problem persists I don't know what to do next.