My Powerhouse pH 2400 Pi inverter generator has been running fine until a couple nights ago it quit. I took the case off and found the bracket holding the solenoid was broken I replaced the bracket tried to start it with the electric starter for about a minute then I stopped. In the morning I went back out and it started. Last night I started it was running for about a half an hour and then just stopped again. I went out and it started back up and read for about five more minutes and then stopped again. Now when turning it over with the starter, it just stutters a little but won't start. When it quit running it quits like you turned it off
Cars & Trucks
Answers & Comments
You can get guide from many sites.. i know few
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thing is covered
within seconds u can get the access and it's totally illustrative complete.. eg. pls try reliable-store.com
Not a question for the automotive car and truck group but it sounds to me like you are overloading the generator and it's internal fault protection is turning it off