The Ricoh copier error code 101 / SC101 is an exposure lamp error or the SBU board is defective. It can also mean the standard white level on the glass was not detected properly. Also, check if the scanner is blocked or if the dirty white plate underneath the glass is obstructed. Try cleaning the glass with water. To reset this error try the code: "Clear Mode"+107+"Clear/Stop" hold for 5s. Turn ON and OFF the Main Switch.If its not a cleaning issue you most likely need a technician to replace exposure lamp or SBU board.
Answers & Comments
The Ricoh copier error code 101 / SC101 is an exposure lamp error or the SBU board is defective. It can also mean the standard white level on the glass was not detected properly. Also, check if the scanner is blocked or if the dirty white plate underneath the glass is obstructed. Try cleaning the glass with water.
To reset this error try the code:
"Clear Mode"+107+"Clear/Stop" hold for 5s.
Turn ON and OFF the Main Switch.If its not a cleaning issue you most likely need a technician to replace exposure lamp or SBU board.