My Proform 3.6 treadmill began stopping when running at higher speeds then went bang. I've had the motor tested but it looks like a small finger-nail piece of plastic has blown off the circuit board any new fuse just blows. Any ideas, is it the board itself and if so where can I get a reasonably priced replacement
LED Blink Patterns on the Control Board Treadmill If after you did check very well the Control board motor, os bad. go to amd ask for rebuild or used in Ebay.
http://www.treadmilldoctor.com/ or eBayeBay Blessing. [email protected] cell+whatsAPP:+50588611441
Answers & Comments
LED Blink Patterns on the Control Board Treadmill
If after you did check very well the Control board motor, os bad. go to
amd ask for rebuild or used in Ebay.
http://www.treadmilldoctor.com/ or eBayeBay
Blessing.
[email protected]
cell+whatsAPP:+50588611441