My truck won't start after putting a bypass pulley on it
We to the ac off and put a bypass pulley on it and bumped the engine to get the belt on all the way now it won't start and sounds like it has no compression to it wat happened
Cars & Trucks - AC
Answers & Comments
Make sure you secured the hose to the air filter tightly. I sure you had to take that off to get replace the belt and bypass.Replacing the AC Compressor will not cause it to not start. I just had the exact same issue with my ford explorer. By pass and idle pulley replace. As I can recall, I did not have the air intake fully tight which I ran into a non start engine. .
Probably damaged the crank position sensor while fitting the belt